The instruction for users the Nano - modifier

In fuel - 0,5%...1,0%

Note: it is possible to lower quantity of oil up to 3...6% (synthetics/castor oil 50%/50%)

For impregnation of friction surfaces of motors - with a shallow layer to smear friction surfaces:

• orifices in a connecting rod, in the piston, the pin, a journal of a shaft, the piston outside and the sleeve inside - to grease NM and to rub with fluoroplastic laps with the greatest possible interference during 1 mines, and then to fry these details at 160 gr.C 1 hour
• bearings with the plastic separator to grease and fry at 100 gr.C 1 hour
• rubber rings to grease NM and to warm up at temperature 60 gr.C 20 minutes
• it is possible to grease threads simply as routine oil and to warm up at 100 gr.C 1 hour
• reduction gearbox can be greased and warmed up simply at 120...160 gr.С 1 hour

For a propeller - simply to rub a propeller with a rag, impregnated the Nano - modifier

For a surface of model - to add in methanol of 0,5%...1,0% and simply to wipe a surface of model a rag, impregnated this solution

For cables and cordobas - to add in methanol of 0,5%...1,0%

• handling a cord in laboratories - to dip a cord into a solution and then to give to dry out, warm up at temperature 100-120 gr.C 1 hour
• handling a cord in field conditions - to put a solution a rag as required

For rubber FAI F1B - to add NM in methylic or isopropanol of 0,5%...1,0% to dip rubber into this solution on 1-2 minutes, to take out, crumple and give alcohol to dry, and then to warm up at 60 gr.C 1 hour and to grease with customary lubrication